Forums Forums Enthusiast Forums A - Z Autowirral MGCraig - MG ZS

Wench has been on the beer

Do you not think Starlet Craig or Princess Craig have a certain ring to them

Liking Princess Craig

Spamming my Topic with Drivel...

For Shame

Calm down Princess, love.

A Princess calm down you know you love it darling lol

PS give me back my go-kart trophy

That Kart trophy is the only one I have, and is now fully displayed in the museum of gayness....aka my room

Any plans for an induction kit / exhaust for this matey

...the revvy K Series do sound rather nice with some breathing mods

Even if you are stuck for funds - a drilled airbox sounds well, and its free

agree with beaker, I fitted an induction kit(pipercross) and it was more than enough roar lol. The x power janspeed system I got at a later date also sounded nice but you really have to work the engine to get the nice sound. With normal driving the induction kit was louder and the exhaust note was almost like the original. I would go for the x power system as when you sell the car the system will still be worth a lot as mg enthusiasts really want them as they are limited now.

You and that drilled airbox obsession I agree though bud, some induction and watse management will sound nice. Have you considdered dropping a V8 in it.....(sorry private joke some birdbrian on cw always use to go on about how easy a rover V8 goes in to any rover)!

Would be nice to get a proper exhaust and air filter...engine management etc etc...but the small problem of money..or lack of prevents this


Ive found the proper power band though, which I like.
Went from a 50mph average speed thing on the motorway to "normal" speed, and shot past 2 stripped out modded Cars (Mk IV Fiesta and Corsa) with the greatest of ease. And yes. They were both gunning it, and didnt seem to impressed HAHAHAHA

GUTTED!!

Right...well,

Cars electrics all fixed etc etc/

The dent that appeared in my front left wing was also mysteriously fixed....which makes me happy

I should be receiving my replacement Centre Cap pretty soon...so my wheels will no longer be naked

I am ordering my Rear Bumper Exhaust surround tomorrow, to try and clean up the mess the flid of a previous owner created before me. Basically, it means Ill mark out where its going to go on the bumper, and then cut the correct and appropriate section of the bumper away, to allow for the exhaust to protrude.


Ive decided to get a replacement exhaust, as my current one is suspect, and looks a bit small and puny. Im hoping to buy a secondhand 1.8 ZS pipe, which will keep the car looking standard and sexy, whilst also making it a bit louder. Until then though, I may just cut the current one back, so it doesnt protrude like a virgin on a nudest beach.

Then, Ill look into a cold air feed, or maybe just do the standad K&N filter jobby. Whatever it takes to get that awesome K Series sound growling round the place.

Wish me luck

Exellent dints that fix themselves love it lol